Back To Back Wall Hung Toilet Carrier

The carrier hardware includes nuts and washers for fastening carriers to a wall.

Back to back wall hung toilet carrier.

That's pretty common with back to back wall hung toilets. Jmenacker (wv) many times a wall mounted water closet with horizontal carrier in a women's room is backed up to a urinal in the men's room. Make necessary adjustments for alignment of studs.

The required chase size may depend upon the type of carrier used. The y connector directs the water downward, eliminating direct flow into the opposite waste line. Slip gauge over studs and hold tight against wall.

( l = 4”) 300 lb. Assemble fiber washers and josam cap nuts to two studs on the center line of the closet outlet and one other stud below and tighten with a wrench. Please contact your toto sales representative for iot pricing.

See our complete line of water closet carriers and fixture supports here. Adjust bearing washers and nuts to fit tight against back of gauge. Hold gauge tight against wall and adjust outlet coupling flush with pad corresponding to closet horn depth.

314 heavy duty horizontal low flow narrow wall carrier. I have seen some people support the bowl to the floor. The holes may even be a little larger than the bolts that go through the holes.

Check for plumb and level. You may think this is trivial but not to the folks with some disability,. The specific purpose is to insure that specifiers provide sufficient wall space to properly install and all dimensions shown are minimum and can be increased to accommodate required variations or accessories.